Re: [Emc-users] gremlin.py for a lathe

> From: [EMAIL PROTECTED]
> To: [EMAIL PROTECTED]
> Date: Sat, 25 Feb 2012 19:27:45 +1100
> Subject: [Emc-users] gremlin.py for a lathe
> 
> Has anyone successfully run gremlin.py standalone (using gremlin-run) with a
> lathe?  
> 
> When I run it, it is always showing the XY plane, not the ZX plane.  I've
> tried setting self.current_view = 'y' (assuming this means view down the y
> axis), but no matter what I set this to, it is always shows the XY plane.
> 

try self.set_current_view() after setting the view with self.current_view = 'y'

Chris M
                                          
------------------------------------------------------------------------------
Virtualization & Cloud Management Using Capacity Planning
Cloud computing makes use of virtualization - but cloud computing 
also focuses on allowing computing to be delivered as a service.
http://www.accelacomm.com/jaw/sfnl/114/51521223/
_______________________________________________
Emc-users mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/emc-users